Category:Reference - Revision history

Jrheinlaender: Continuation lines

2018-11-21T17:46:49Z

Continuation lines

← Older revision		Revision as of 17:46, 21 November 2018
Line 2:		Line 2:

	All iMath commands start with <code>%%ii</code> at the beginning of a line, which will be interpreted as a comment by Office. When the document is recalculated, iMath parses the text after the <code>%%ii</code> and generates the formula that is displayed. The generated lines are marked by <code>%%gg</code> at the end of the line. Editing such a line makes no sense because it will be deleted at the next recalculation! Always modify the <code>%%ii</code> lines if you want to tweak an iFormula. Formulas may also have lines without either <code>%%ii</code> or <code>%%gg</code>. At the next recalculation, iMath will convert these into <code>%%ii TEXT</code> lines.		All iMath commands start with <code>%%ii</code> at the beginning of a line, which will be interpreted as a comment by Office. When the document is recalculated, iMath parses the text after the <code>%%ii</code> and generates the formula that is displayed. The generated lines are marked by <code>%%gg</code> at the end of the line. Editing such a line makes no sense because it will be deleted at the next recalculation! Always modify the <code>%%ii</code> lines if you want to tweak an iFormula. Formulas may also have lines without either <code>%%ii</code> or <code>%%gg</code>. At the next recalculation, iMath will convert these into <code>%%ii TEXT</code> lines.

			Note on version 2.2.8 and higher: iFormulas can now continue over several lines using the syntax <code>%%ii+</code>.

Jrheinlaender at 14:21, 2 July 2017

2017-07-02T14:21:32Z

← Older revision		Revision as of 14:21, 2 July 2017
Line 1:		Line 1:
	~~Here you~~ will ~~find all~~ the ~~elements~~ that ~~can~~ be ~~used~~ to ~~build iFormulas~~.		It is recommended to always use the iMath menus to create or modify iFormulas. Nevertheless, sometimes it will be necessary to fine-tune iFormulas by editing them directly.

			All iMath commands start with <code>%%ii</code> at the beginning of a line, which will be interpreted as a comment by Office. When the document is recalculated, iMath parses the text after the <code>%%ii</code> and generates the formula that is displayed. The generated lines are marked by <code>%%gg</code> at the end of the line. Editing such a line makes no sense because it will be deleted at the next recalculation! Always modify the <code>%%ii</code> lines if you want to tweak an iFormula. Formulas may also have lines without either <code>%%ii</code> or <code>%%gg</code>. At the next recalculation, iMath will convert these into <code>%%ii TEXT</code> lines.

Jrheinlaender: Created page with "Here you will find all the elements that can be used to build iFormulas."

2017-06-24T05:51:29Z

Created page with "Here you will find all the elements that can be used to build iFormulas."

New page

Here you will find all the elements that can be used to build iFormulas.